地暖的安装（Heating installation）.doc

地暖的安装（Heating installation） The construction preparation (including cleaning ground), fixed points, collector, laying insulation plate and boundary expansion zone, warm reflective film, laying coil (PEX, PERT, PB): the heating coil laying order is laid from far to near one by one ring, all through the ground heating coil expansion joints are the expansion a separate ground heating coil shall be expansion joints here, expansion joints for the heating coil for expansion joints, the interface is connected to the heating pipe variety determination. To be divided in advance of civil construction and installation, set the door joints in construction (including wire mesh cover), intermediate acceptance (a hydraulic test) to backfill the fine stone concrete layer, the completion of acceptance (two pressure test). (special thermostat installation completed at the end of last), drawings, accurate location and location mark buried coil temperature sensor. The conventional anatomical Figure warm construction 2, cleaning, construction waste and dust 3, laying insulation layer: The laying of ground insulation layer should be smooth, dry, no debris. The root should be flat and straight wall and no fouling phenomenon. The laying of the insulation layer should be formed, the insulation layer between the joints should be tight. Direct contact with the soil or moisture into the ground, laying in the insulation layer should be laying a layer of moisture-proof layer before. The polystyrene board insulation layer thickness (mm) between the floors floor insulation layer 20 with the insulating layer of soil or outdoor air adjacent to the floor of the 40 Pay attention to insulation corner settings and in place The set of joints: 1. in the stretching and the external walls, columns and other interfaces should be laid through uninterrupted expansion joints, joints should be used to lap, lap width not less than 10mm; the expansion joints and fixed wall and column should be reliable, and the gr