放样全部步骤（All the steps of setting out）.docVIP

放样全部步骤（All the steps of setting out） Total station coordinate with process steps The best answer 14. measurement lofting The measurement for measuring lofting of the required point in the field. In the layout process, through the control on the angle and distance or coordinate measuring instrument, will show setting out the pre input value and the measured value of the difference to guide the layout. Show = measured value - setting value Lofting survey should be conducted using the left plate position. 14.1 distance measuring lofting To set the required point according to a reference direction around the horizontal angle and distance to the station. The operation process of the operation button to display 1. as shown on the right a reference direction. 2. in the measurement mode second page menu under [zero], [in] zero flashing again when the key is pressed, the reference direction is set to zero. [zero] [measurement] H ZA 99 degrees 43 13 HAR 0 degrees 00 00 P2 Zero coordinate record The operation process of the operation button to display 3. in the measurement mode second page menu under [] into the measurement model lofting lofting. In the menu select 2. Surveying to accomplish the same function. ? [out] [survey] 1. sampling data 2. observation layout 3. station setting 4. azimuth The selection of 4. 1. sampling data by [], enter the setting out data input screen. The horizontal distance and angle input lofting lofting, each finished a data item and press []. [] [distance] lofting Hm: HA: Coordinate 5. press [OK] to enter the observation screen layout. Among them: DH: target and the horizontal distance between data points. DHA: and the target of setting out the horizontal angle difference. [OK] [distance] lofting DH DHA -119 at 23 18 HAR 0 degrees 00 00 Correct measurement mode 6. [] according to the guide into the loft boot screen display, second line angle value is measured and the angle difference setting value, and the direction of the arrow as the instrum