日产骐达怠速匹配（Nissan, idle）.doc

日产骐达怠速匹配（Nissan, idle） I am looking for a method of learning on the Internet do not know it! The owner because in a hurry now said to go to the 4S set! Methods we see is not feasible! Note: Kim KT600 and K300 users can directly use the instrument to do: Simple: CAN - car - joint selection of NISSAN, the instrument enters the engine system into the work support, choose second idle learning operation - over time you will see the idle speed slowly decline. (NISSAN on idle learning condition requirements are relatively high, the water temperature should be between 90-95 degrees, the fan can not rotate, not Guadang, can not step on the brake and accelerator, let the car no load conditions, attention!!!) Manual method: Idle air quantity learning (do not use the CONSULT-II diagnostic method): Explanation: the idle air volume learning operation learning speed of the engine is maintained within a predetermined range of idle air. In the event of any of the following circumstances, this operation must be carried out: The time of replacing electronic solar term door control actuator or ECM. The ignition timing at idle or outside the specified range when. Dead work Idle air volume learning before the confirmation of all the following conditions are met. Even if it is an instant, if any one of these conditions is not satisfied, learning the operation will be canceled. The battery voltage is more than 12.9V (idle) - starting the engine and the engine temperature rises to normal working temperature. The engine coolant temperature: 70 - 100 C (158 - 212 F) PNP - switch: ON The electrical load switch: OFF (air conditioning, headlights, rear window defogger) The steering wheel: the middle position (straight forward position) - speed: stop The gearbox has been preheated: For the use of diagnostic CONSULT-II A/T models, the vehicle until the A/T system DATA MONITOR (data monitoring) mode in the FLUID TEMP SE (oil temperature sensor) display value less than 0.9V. The first step: the rele