灯具安装（Lighting installation）.docVIP

灯具安装（Lighting installation） The basic requirements, installation of lamp apparatus Outdoor lighting installation should not be less than 3m (installed on the wall when not less than 2.5m): Each lamp lighting circuit and the socket number of not more than 25 (not including the lantern, and loop) should be 15A and fuse protection. The lamp installation should meet the following requirements: 1) voltage shall not exceed 36V; 2) particularly humid places or good conductivity on the ground, if the work site stenosis. The mobility (such as working in the boiler, metal container), voltage lamp shall not exceed 12V. The chandelier lamp weighs more than 3kg, shall be embedded in the hook and bolt. Soft core limited to below 1kg, more should be added to the chain. Metal halide lamp installation shall meet the following requirements: L) lamp installation height should be more than 5m, the surface terminal connection and not to the power line near the lamp power line should be; 2) tube must use a trigger and limiter matching. The factory has a safety lamp, lamp lamp, waterproof and dustproof explosion-proof lamp and high pressure mercury lamp etc.. Street branch road corner lamp and high pressure mercury lamp and high-pressure sodium lamp. Technical requirements for the installation of 2, switch, socket, ceiling fan In the eyes of the socket, the socket terminal power zero line terminal connected to a power supply socket on the right line; in the three eye socket, above the ground terminal socket, the left socket terminal connected to the zero line of the power supply, the power line terminal jack. The fan blade height should not be lower than 2.5m. 3, lighting distribution box installation Lighting distribution box type is various, but the installation way is nothing more than a suspension type surface mounted and embedded concealed two. Suspension type distribution box can be installed on the wall or pillar. The embedded distribution box installation is usually mixed with civ