cisco硬件防火墙（Cisco hardware firewall）.docVIP

cisco硬件防火墙（Cisco hardware firewall） PIX review: What is PIX? PIX is a firewall series equipment developed by CISCO company, which mainly plays the role of strategy filtering, isolating internal and external networks, and setting up DMZ (ceasefire zone) according to the actual needs of users. Like general hardware firewall, it has the characteristics of fast forwarding data packets, many kinds of rules to be set up and flexible configuration. The latest version of PIX is PIX535. Installation of PIX: The PIX firewall is similar in appearance to the router. (Figure 1) the front has no interface and only shows the indicator light. All interfaces are on the back of the PIX firewall. (as shown in Figure 2) You will find that the device has many interfaces, from the RJ45 to the USB interface, from the monitor interface to the power interface. We further enlarge the back of each interface, you can see more clearly. (as shown in Figure 3) According to the instructions in the diagram to find the corresponding interface, of course, by default only these interfaces, if we want to add a type of interface, you can also remove the corresponding panels, install new interfaces. The most we use are the console port (console) and the Slot5, Slot6 (RJ45 network interface). Install PIX and install common routers and switches. Fix the equipment on the cabinet with a spike pin, and pay attention to the heat supply and the UPS uninterrupted power supply. Regional division of PIX A new PIX firewall can not be put into use without any configuration. We need to use the CONSOLE line to connect the CONSOLE port of the device and set it according to the actual application environment. The login PIX management interface is very simple, and the CONSOLE line can be connected to the console interface. Before configuring the PIX firewall, readers should follow me to understand the physical features of the firewall. The firewall is usually has at least 3 interfaces, but many of the early firewall only