江南快速电梯调试与培训ppt.pptVIP

目 录 电动机参数自学习 Motor auto-tuning 电梯安装检修运行 Inspection running 电梯快车运行调试 Normal running 电梯常见故障表 Error code list 系统简介system description in brief 系统结构介绍 电梯安装检修运行 Inspection running 曳引轮转动方向或转速不正确，处理方法如下: If the rotational direction of driving sheave and rotate speed is not correct, please see the following: l??转动方向正确，但转速极慢，并有轻微抖动时，变换编码器的A相和B相的相位即可 If the rotational direction of driving is correct, but the rotate speed is very slow, change phase A and B of the encoder. l????转动方向相反，转速极慢，变换曳引电动机输入电源相位即可 If the rotational direction of driving is contrary, but the rotate speed is very slow, change the power phase of traction motor. l????转动方向相反，转速正常，编码器和电动机输入电源相位都要变换。 If the rotational direction of driving is contrary, the rotate speed is correct, change both the power phase of traction machine and phase A and B of encoder. 电梯安装检修运行 Inspection running 在机房内点动检修盒，电梯运行正确以后，两个方向连续多次地以短距离（1m左右）运行电梯，在电梯各部件没有误动作和异常响声后，把电梯停靠在安装人员从顶层面能方便进到电梯轿顶。为电梯作安装检修做准备。 Press the down button in controller, after the lift running well, move the lift continuously in the short distance (about 1m) in two orientations. If the lift runs well and has no abnormal noise, stop the life in the position where the operator can access to the top of the car, prepare the installation of the lift. 分别在控制柜和轿顶分线盒插上随行电缆中插接件及轿顶检修盒到轿顶分线盒的插接件。而其余不用接插。 Plug plugs to the junction box and to the controller , connect the inspection box to the junction box on the top of the car. 电梯安装检修运行 Inspection running 关闭顶层厅门，在轿顶点动操作上下行按钮，注意电梯运行方向，要与动作的按钮方向一致。 Close the landing door of the top floor, press the up or down button, check if they work well. 在电梯的安全行程（上下限位）内，以检修运行个来回。仔细观察安装好的部件与轿厢之间是否挂碰，相对位置及距离是否准确，保障安全。 Inspection operation, look into if the installation parts and car is collide, opposite position and distance is exact. 电梯快车运行调试 Normal running 在控制主板上输入电梯常规运行参数。如下参数必须设置正确 set general parameter