引起密封泄露的因素（Factors causing leakage of seal）.docVIP

引起密封泄露的因素（Factors causing leakage of seal） The factors of seal leakage caused by.Txt First, factors causing the seal leakage (1) installation problems: The 1 seal installation direction error caused leakage With 2 installed, or in the pipeline into the foreign body, dust, sealing leakage 3 damage caused by leakage caused by poor sealing assembly Scratch on the surface of the sealing rod caused by leakage 4 5 welding process, 6 concentricity enough lead to eccentric, partial load caused by leakage The 7 coating processing unevenness, coating into the sealing ring (2) sealed with the problem 1 because of the pressure caused by excessive clearance bites 2 mixed air, caused by adiabatic compression seal burning The 3 sealing material and medium incompatible, causes the expansion of materials such as metamorphism reflect 4 high temperature caused by material deterioration of slightly 5 due to low temperature hardening, shrinkage caused leakage two 6 high frequency reciprocating motion to seal fever, dry grinding 7 low pressure, low speed, unstable movement 8 bad lubrication resulting in seal wear 9 because of the component by the vibration due to leakage 10 environment caused by dust seal abnormal wear 11 seal groove rust caused by leakage (3) seal assembly design The 1 guide supports improper material selection, damage of cylinder, piston rod 2 clearance is not appropriate, resulting in gap extrusion bite Thread 3 cylinder piston cylinder end of the guide angle properly, damage the sealing ring 4 stiffness, weight calculation error caused by the bad state of motion 5 seal installation guide angle improper sealing ring damage 6 sliding surface roughness is not suitable for wear of the sealing ring 7 electroplating uneven sealing hole, through the surface scratches, wear of the sealing ring The 8 sealing grooves, especially the shaft sealing groove rough enough, wear, damage to seals 9 piston, piston rod coating pores cause leakage 10 bad lubrication wear, bite cylinder,