电缆终端头与中间接头的运行要求及制作（Operation requirements and manufacture of cable terminal head and intermediate joint）.docVIP

电缆终端头与中间接头的运行要求及制作（Operation requirements and manufacture of cable terminal head and intermediate joint） The rain cover is to ensure the outdoor cable terminal and wet flashover voltage enough, at the top of the four step, when used according to the outer diameter of the cable insulation, will be part of the ladder resection. (2) PVC adhesive tape, sealing for cable terminal and intermediate joints, but can not rely on it for a long time for sealing. (3) self adhesive rubber belt, it is a non vulcanized butyl rubber and polyisobutylene based, self-adhesive insulation and good performance, in around half an hour after that can self into a whole, so it has good sealing performance. But it has low mechanical strength, not light, easy to crack, so the outside of the package also two layers of black PVC with protection layer. (4) black PVC belt, the plastic band than general PVC with good aging resistance, its non sticky and thick, so in the end is wrapped, anti loose, but also with the tie line. 2.2 cable terminal (1) stripping plastic coat: according to the space between the cable terminal installation position to the coupling device is decided by the distance from the end of the general plastic stripping size to section plastic mouth distance is not less than 900m. (2) saw armored layer: in section 20mm from plastic mouth tied line in tie line side steel a sawed off, saw the mouth will be unified with filler and the interphase resection. (3) welding wire: 10 ~ 25mm2 of the plurality of soft copper divided into three shares in each phase of the shield laps around, if the cable shielding aluminum shielding, grounding wire should be tied to the shield; if the copper shield should be welded. (4): a set of gloves and Changang package at the end of cable core with transparent PVC belt, glove sleeve, elastic should be moderate. Set into the gloves, belt wrapped with transparent PVC gloves in the end. With black PVC tape wrapped two layer. (5) peeling shield: from the finger