电议考试题（Electric examination questions）.docVIP

电议考试题（Electric examination questions） 1 power meter range (including current, voltage and power) three. 2 AC motor control can be divided into (servo motor, tachogenerators and autosyn) three categories. 3 self coupling transformer has a plurality of (TAP), in order to obtain different (ratio). The cage type motor starting autotransformer, the starting current and starting torque according to the ratio of the (square) times lower. This method for capacity (larger) can work normally and then into (Y) and with (Y) - (a) cage type motor. 4. Work in electrical equipment, technical measures to ensure the safety of (electricity, electricity, installation of grounding wire, hanging signs and temporary barriers, after work to restore power). 5 insulation treatment process including (pre drying, impregnation and drying process) three. 6 starting method of synchronous motor (with auxiliary motor) starting method and starting method (FM), (asynchronous) starting method. Is the most commonly used (asynchronous) start. From 7. (power supply, switch, wire and resistance), composed of the circuit called simple circuit 8. at the time of switching operation is not allowed to be mechanical and electrical misoperation locking device (relief), under special circumstances such as required (lift), must pass through the long agreed value. 9. current measurements should be multimeter (Series) in the circuit under test, measuring the voltage when the multimeter (parallel) in the measured circuit 10. in the operation of the transformer, the total loss is changed with the load change, which is the same (iron loss), and (copper consumption) is changing. Two The resistance of the 1. conductor, and the conductor section length not only relevant, but also with the conductor (D) on. A. B. C. D. material temperature humidity range 2. DC motor to achieve reverse polarity on the electric power need, the polarity of the excitation power supply (A). A, B, and C remained unchanged and change can be reve