触点润滑剂工作原理及实际使用效果（Working principle and actual application effect of contact lubricant）.docVIP

触点润滑剂工作原理及实际使用效果（Working principle and actual application effect of contact lubricant） Contact lubricant working principle and practical effect Electrical contact switch is one of the important parts of electrical contact system, through the analysis of the failure factors of contact and failure mechanism, discusses in detail the effect and mechanism of improving new technology of contact protection and lubrication on electric contact reliability, and puts forward the selection and use of the principle of contact lubricating agent. Factors affecting the contact surface between the current flux Before the mechanism to improve the performance of electrical contact lubricant to contact, we must first understand some main factors affecting the contact surface between the current flux. The 1. contact corrosion Usually, the contact is in sealed or unsealed environment. Contact working in non sealed environment, due to different pollutants containing nature in the air, the metal surface will be exposed to different degrees of pollution. Even if the work in sealed contact, because of the characteristics of the working medium can also decompose and release organic gases with different content and nature, it will cause the contact surface to different degrees of pollution. Direct harm to the contact surface caused by pollution is caused by pollutants in surface contact resistance contact surface increased significantly. In order to make electrical contact system bear the current carrying work can work normally, to effectively remove this protective film. 2. contact between the arc erosion The electrical contact system, when the contact is closed or open load, arc discharge phenomenon often occurs on the current strength of about 1A above the switch device. The local high temperature arc discharge will make the contact surface of the moment, caused by melting, gasification and metal surface deformation, but also the internal surface of metal impurity contamination of gas in th