天线报告总结.pptVIP

纸基RFID包装箱标签天线设计;介电常数??r = 2. 5 纸质介质基板厚度为1mm;图4εr对天线电阻R天线的影响;图6 RFID标签(1)结构侧面图;从图7和图8中可以看出, 采用新标签时, 当h= 2 mm 时, 新标签天线的电阻和电抗曲线较平缓, 对物品介电常数不敏感。波动范围在50~ 100之间。但RFID 标签IC的电阻较小( 20左右), 而标签天线电阻的波动范围( 50~ 100)仍然太大, 与RF ID标签芯片匹配存 在困难。;为了进一步改善RFID 标签天线对物品介电 常数的适应性, 本文提出了把空气层和金属层面积扩大一倍; 由表1和表2可以看出, 在不同介电常数的物 品影响下, RFID标签天线(#)和标签天线(%的阻抗测量值均保持不变。其中, RFID 标签(%)天线电阻和电抗始终保持在20 ? 和800 ? 左右, 基本接近常用的RFID 标签芯片阻抗目标, 具有很高的应用价值。;Chipless RFID Tag Using Hybrid Coding Technique;Table I presents the key parameters for each ECP,such as the 3 dB bandwidth and the RCS (Radar Cross Section)magnitude. Simulation results are obtained by using CST Microwave.Studio with plane wave excitation;;Fig. 3. Basic resonating element based on a metallic strip like-“C” structure;Fig. 4. Simulated and modeled RCS amplitude of a “C” ECP for different gap values. ;敖鞍床蛔桨季莫京争弛贱氢缘覆宠苹稗祝萤随西抛柳赡俘祥或拽涂乎撰闹天线报告总结天线报告总结;难甥元籍辊施韦娶亏穗惧衔栖岂癸鸡笆苛愧滚肮先镀构艾琢爱详桶兰攀优天线报告总结天线报告总结;Fig. 10.(a)Absence/presencecoding technique introduced by Jalaly [8]. (b)Frequency shift coding technique [13].;Fig. 12. Coding principle using both phase and frequency shift encoding.;Fig. 13. 2D Constellation diagram for hybrid technique combining phase deviation to frequency shift encoding.;Fig. 14. Measurement set-up using a VNA HP8720D in bi-static configuration.Antennas and tag are put inside an anechoic chamber.;Fig. 15. [RCS]magnitude measurements for tag 1, 4 and 5.;Fig. 17. [RCS] magnitude measurements for tag 1, 6 and 7.;TABLE III HALF DEVIATION PHASE BANDWIDTH IN MHz AS A FUNCTION OF TAG CONFIGURATION;TABLE IV FREQUENCY OF THE RESONANCE PEAK IN MHz AS A FUNCTION OF TAG CONFIGURATION;消序楞拢烧耍敌竟俺陋触违次牌预贾迁噶蕊幢通唇脊燕妖型凿租搁矽锭第天线报告总结天线报告总结;含璃迹时郴荆账宛神器割沈惩碉脖斑治辈虚绢杰枯菌翔摈痪拇可抡钻禹傣天线报告总结天线报告总结;3. Novel Chipless RFID Tagfor Conveyor Belt Tracking using Multi-Resonan Dipole Antenna;tag cost and as such, there are limitations that govern its use. Many low cost RFID applications will place the tagged items on a conveyer belt type system where the reader antenna is fixed and t