径向分块双压边圈轴对称拉深成形工艺研究.pdfVIP

1, 2 3 4 秦泗吉 黄晓忠 王 婧 1. 燕山大学, 秦皇岛, 66 4 2. 北京有色金属研究总院有色金属材料制备加工国 重点实验室, 北京, 1 88 3. 上海交通大学, 上海, 2 3 4. 杭州师范大学, 杭州, 31 36 : 为提高板材拉深成形的成形极限并获得更好的压边效果, 提出了轴对称拉深成形工艺的径向 分块压边方法采用理论分析有限元模拟以及实验研究的方法, 对圆筒形零件分别在双压边圈和整体 压边圈作用下的拉深成形过程进行了分析研究研究结果表明, 与传统压边方法相比, 采用径向分块压 边方法可以对径向不同变形质点分别压边, 有效提高拉深成形极限, 并获得更好的压边效果 : ; ; ; : T G386. 4 1 : 1 4 132X( 2 11) 14 1741 4 Research on Axisymmetrical Deep Drawing Process Based on Radial Double Segmental Blank- holder Technique 1, 2 3 4 Qin Siji Huang Xiaozhong Wang Jing 1. Yanshan U niversity , Qinhuangdao, Hebei, 66 4 2. State Key Laboratory for Fabrication and Process of Non- Ferrous Metals, Beijing General Research Institute for Non- Ferrous Metals, Beijing, 1 88 3. Shanghai Jiao T ong U niversity, Shanghai, 2 3 4. Hangzhou Normal U niversity, Hangzhou, 31 36 Abstract: A radial segmental blank - holder technique w as proposed herein for axisymmetrical deep draw ing process to improve blank - holder effect and raise the forming limit. Deep draw ing processes under single and segmental blank holder w ere analyzed theoretically , experimentally and by finite element method respectively . The results for forming process of cylindrical parts show that it can carry out blank holding for different radial deformation zones by radial segmental blank- holder tech nique. Also, the blank- holder effect is enhanced more effectively and the forming limit increases by radial double segmental blank- holder technique comparing w ith that by conventional one. Key words: deep draw ing process; blank holding