民族传统日走访慰问活动.doc

苜蓿台社区开展古尔邦节走访慰问活动 在穆斯林传统节日“古尔邦节”来临之际，积极组织开展向少数民族走访慰问等形式多样的活动，将深切关怀与温暖爱心送到心间，确保在节日期间少数民族过上一个安乐、祥和的节日。 开展庆古尔邦节文体活动 活动现场热闹非凡，代表哈萨克族优秀民俗文化的“黑走马”表演将全场的氛围提向了高潮。各个哈萨克牧民人们弹奏着冬不拉，全场所有百姓和机关干部们一起加入到表演中，跳起了欢快的舞蹈。活动现场的哈萨克族民俗歌曲演唱、舞蹈、对诗等文艺表演获得了在场所有观众的一致好评。文艺演出过后，在场的百姓还积极参加了拔河、抢凳子等体育活动，在享受文化熏陶的同时也丰富了农闲生活，拉近了各民族之间的距离。 活动结束后，农民朋友们纷纷表示，希望这样的文体活动能多举办一些，能邀请更多的人来参加，让大家在农忙之余也能感受到浓浓的民俗文化，为我乡的和谐稳定奠定了基础。 托里乡苜蓿台社区 2014年10月5日 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technic