U盘装系之U盘启动盘制作.doc

计算机系列教学文档 ------U盘装系统之U盘启动盘制作 文件状态： [ ] 草稿 [√] 正式发布 当前版本： V1.0 作 者： 李星华 完成日期： 2014-11-08 个人博客：  U盘装系统之U盘启动盘制作 本文分为两部分，第一部分简单的介绍了U盘 U盘启动盘分区情况 第一个分区二/s/1nt9hoST”。 下载“老毛桃U盘工具V2013超级装机版.rar”后进行解压缩，解压缩完成后点击文件夹里的“LaoMaoTao.exe”，如下图所示： 启动老毛桃U盘工具 U盘工具启动后，将U盘插入，此时会自动检测U盘的盘符（本例U盘不F盘），如下图所示： 老毛桃U盘工具主界面 接下来点击“一键制作成USB启动盘”按钮，会出现“信息提示”界面，点击“确定”按钮即可，如下图所示： U盘启动盘制作提示信息 在制作完成时会有信息提示是否进行模拟启动，我们点击“否”即可，如下图所示： U盘启动盘制作完成 此时U盘启动盘制作完成，默认U盘里面有一个文件，名称为“LMTinud.exe”，或一个是文件夹“GHO”，如下图所示： U盘启动盘内的文件 U盘启动盘制作完成，但不代表能安装系统，此时还需要我们上网下载ghost版本的系统（根据你安装的系统来下载相应的ISO文件），并复制文件到 “GHO”文件下，此时可以作系统的U盘才真正完成。 如果想知道如何安装系统，请参见“U盘装系统之系统安装”。 计算机系列教学文档 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time,