solaris操作系统简介和安装.pptVIP

配置主机名 Host Name ? On this screen you must enter your host name, which identifies this system on the network. The name must be unique within your domain; creating a duplicate host name will cause problems on the network after you install Solaris. ? A host name must be at least two characters; it can contain letters, digits, and minus signs (-). ? ? Host name: ? ? F2_Continue F6_Help 配置IP地址 IP Address for ce0 ? On this screen you must enter the Internet Protocol (IP) address for this system. It must be unique and follow your sites address conventions, or a system/network failure could result. ? IP addresses contain four sets of numbers separated by periods (for example 129.200.9.1). ? ? IP address: ? ? F2_Continue F6_Help 选择是否属于子网 Subnets ?for ce0 On this screen you must specify whether this system is part of a subnet. If you specify incorrectly, the system will have problems communicating on the network after you reboot. ? To make a selection, use the arrow keys to highlight the option and press Return to mark it [X]. ? ? System part of a subnet [X] Yes [ ] No ? ? F2_Continue F6_Help 配置子网掩码 Netmask for ce0 ? On this screen you must specify the netmask of your subnet. A default netmask is shown; do not accept the default unless you are sure it is correct for your subnet. A netmask must contain four sets of numbers separated by periods (for example 255.255.255.0). ? ? Netmask: 255.255.255.0 ? ? ? ? F2_Continue F6_Help 选择是否启用IPv6 IPv6 for ce0 ? On this screen you should specify whether or not IPv6, the next generation Internet Protocol, will be enabled on this machine. Enabling IPv6 will have no effect if this machine is not on a network that provides IPv6 service. IPv4 service will not be affected if IPv6 is enabled. ? To make a selection, use the arrow keys to highlight the option and press