RG1.211 核电厂安全相关电力与现场接头鉴定 2009.docVIP

RG1.211 核电厂安全相关电力与现场接头鉴定 2009 本文由xdwking贡献 pdf文档可能在WAP端浏览体验不佳。建议您优先选择TXT，或下载源文件到本机查看。 U.S. NUCLEAR REGULATORY COMMISSION April 2009 REGULATORY GUIDE OFFICE OF NUCLEAR REGULATORY RESEARCH REGULATORY GUIDE 1.211 (Draft was issued as DG-1132, dated June 2007) QUALIFICATION OF SAFETY-RELATED CABLES AND FIELD SPLICES FOR NUCLEAR POWER PLANTS A. INTRODUCTION This guide describes a method that the staff of the U.S. Nuclear Regulatory Commission (NRC) considers acceptable for complying with the Commission’s regulations for the qualification of safetyrelated cables and field splices for nuclear power plants. The regulations established by the NRC in Title 10, Part 50, “Domestic Licensing of Production and Utilization Facilities,” of the Code of Federal Regulations (10 CFR Part 50) (Ref. 1) require that structures, systems, and components that are important to safety in a nuclear power plant must be designed to accommodate the effects of environmental conditions (i.e., remain functional under postulated design-basis events (DBEs)). Toward that end, General Design Criterion (GDC) 1, “Quality Standards and Records,” GDC 2, “Design Bases for Protection Against Natural Phenomena,” GDC 4, “Environmental and Dynamic Effects Design Bases,” and GDC 23, “Protection System Failure Modes,” of Appendix A, “General Design Criteria for Nuclear Power Plants,” to 10 CFR Part 50 contain the general requirements. Augmenting those general requirements, the specific requirements pertaining to the qualification of certain electrical equipment important to safety are contained in 10 CFR 50.49, “Environmental Qualification of Electric Equipment Important to Safety for Nuclear Power Plants.” In addition, Criterion III, “Design Control,” of Appendix B, “Quality Assurance Criteria for Nuclear Power Plants,” to 10 CFR Part 50 requires that, when a test program is used to verify the adequacy of a specific design feature, the test program must include suitable qual