cascadable current-mode first-order and second-order multifunction filters employing grounded capacitorscascadable电流型一阶和二阶多功能过滤器采用接地电容器.pdfVIP

Hindawi Publishing Corporation Active and Passive Electronic Components Volume 2012, Article ID 261075, 6 pages doi:10.1155/2012/261075 Research Article Cascadable Current-Mode First-Order and Second-Order Multifunction Filters Employing Grounded Capacitors Jiun-Wei Horng, Chun-Li Hou, Ching-Yao Tseng, Ryan Chang, and Dun-Yih Yang Department of Electronic Engineering, Chung Yuan Christian University, Chung-Li 32023, Taiwan Correspondence should be addressed to Jiun-Wei Horng, jwhorng@.tw Received 28 November 2011; Accepted 28 December 2011 Academic Editor: Daisaburo Takashima Copyright © 2012 Jiun-Wei Horng et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. A configuration for realizing low input and high output impedances current-mode multifunction filters using multiple output second-generation current conveyors (MOCCIIs) is presented. From the proposed circuit configuration, first-order allpass, highpass, lowpass and second-order allpass, notch, bandpass filters can be obtained. The simulation results confirm the theoretical analysis. 1. Introduction and one grounded capacitor with low input and high output impedances. As the function of CDTA can also be replaced Current conveyors (CCs) are receiving much attention for by two CCII and one operational transconductance amplifier their potential advantages such as inherent wider signal (OTA) [12], if the structure of [12] is constructed by CCIIs bandwidths, simpler circuitry and larger dynamic range [ 1,