ch3 无源器件的设计仿真与优化.pptVIP

3.3 波导T接头的优化 2.T优化 优化要求： 波导尺寸：a=0.9in,b=0.4in 隔片尺寸：width=0.45in,thick=0.1in 频率范围: 10GHz 优化参数：offset 优化目标：|S31|2 = 2*|S21|2 2. Set up the Optimetrics Design Save the Tee Project Under a New Name: OptimTee Delete the Frequency Sweep: Will specify in the Solution Setup dialog box, 10 GHz. 3. Set up and Solve the Parametric Analysis Add a Parametric Setup: Right-click Optimetrics in the project tree, Click AddParametric on the shortcut menu. 3. Set up and Solve the Parametric Analysis Add a Variable Sweep Definition: Add Variable: offset Start: 0in, Stop: 1in, Step:0.1in Add 3. Set up and Solve the Parametric Analysis Save Fields and Mesh for Every Solved Design Variation Options tab, select Save Fields And Mesh. 3. Set up and Solve the Parametric Analysis Specify the Solution Quantities to Evaluate: power quantities at Port 1, Port 2, and Port 3, |Si1|2 Calculations tab - Setup Calculations. 3. Set up and Solve the Parametric Analysis Output Variables - Power11=mag(S(Port1,Port1))*mag(S(Port1,Port1)) Power21=mag(S(Port1,Port1))*mag(S(Port1,Port1)) Power31=mag(S(Port3,Port1))*mag(S(Port3,Port1)) 3. Set up and Solve the Parametric Analysis Select Power 11, Power21, Power 31 Click Add Calculation 3. Set up and Solve the Parametric Analysis Solve the Parametric Analysis: Right-click ParametricSetup1, and then click Analyze. 4. Review the Parametric Results Plot of S-Parameter Results vs. offset Position: As septum offset 0.3in, the transmission decreases at Port 2 and increases at Port 3. As septum offset 0.3in, it becomes less effective, reflection increases at the input port, Port 1. maximum value for the optimization to be 0.3 inches. 4. Review the Parametric Results Plot of Power Distribution vs. Offset Position offset=0in, P3/P2=1:1; offset =0.1in, P3/P2~2:1; offset=0.3in, P3/P2~9:1; The goal for optimization is Power31=2* Power21, starting value to be 0.1 inches. 4. Review the Parametric Results Animate the Field Overlay Plot: Offset=0in Offset=0.