镍基高温合金喷射液束电解-激光复合加工试验研究-材料工程.pdf

- 75 - Experimental Study of Hybrid Processing of Jet Electrochemical Machining and Laser Beam M achining on Nickel-based Superalloy , , 2 ( , 2 00 6; 2 , 2 00 6) 2 ZHANG Hua , XU Jia-w en , WAN G J-i ming ( Jiangsu Key Laboratory of Precision and M icro- Manufacturing T echnology, Nanjing University of Aeronautics and Astronautics, Nanjing 2 00 6, China; 2 Department of Applied Physics, College of Science, N anjing U niversity of A eronautics and Astronautics, Nanjing 2 00 6, China) : , - , , GH3044 : 1 5MPa 8% NaNO -90% 3 -, : ; ; ; ; : T G665; T G662 : A : 00 -438 ( 2009) 04-0075-06 Abstract: In order to solve the problem w ith recast layer produced during laser machining on nickel- based superalloy, a new processing of Jet Electrochemical M achining and Laser Beam Machining (JECM-LBM) w as put forw ard. Based on the analysis of principle of JECM-LBM and the study on the properties of laser attenuation in electrolyte, the experimental system w as made, and drilling exper-i ments on a thin GH3044 sheet w ere done w ith the system . The results show ed that recast layer had been reduced more than 90% during JECM-LBM w ith NaNO3 electrolyte of pressure . 5MPa and con- centration 8% , and that the hybrid processing w as feasible w ith applied future for the film cooling holes of aero-engine blades. Key words: laser machining; je