Catia-V5-曲面变形车孽探.pptVIP

曲面优化工具命令 Working With the Generative Shape Optimizer Workbench;曲面优化工具命令 Bump;This task shows how to deform surfaces basing the deformation on curve wrapping, that is matching each reference curve onto a target curve.The deformation is then defined by the transformation of the reference curves into target curves.根据曲线变形（Wrap curve）：参考两个已知曲线的相对关系对原始曲面进行变形，从而得到变形结果。已知曲线不必落在原始曲面上。;Curve Wrapping Deformation with Fixed Reference 曲线变形之固定参考曲线：考虑到在很多场合下，需要与周边曲面保持连续性，此时可以使用通过固定参考曲线，并指定连续类型，点连续，切矢连续或曲率连续。 具体操作：选择参考曲线后，将鼠标移至“ReferenceXXX”字样上，右键弹出下拉菜单，并选择“Fixed reference curve”，同时在对话框里将自动跳过目标曲线的配对，直接换行进入下一个配对的选择，如下图。 并不只是首末参考曲线能设置固定，中间的也可以，只是不能进行连续性约束。;Editing a Deformed Surface 曲线变形之修改编辑：包括增加或移除参考曲线-目标曲线配对，固定参考曲线，添加约束等。 关于约束：只可以对首末参考曲线进行连续性的约束，但不能保证完全约束到位，有时可能只是近似。;曲面优化工具命令 Wrap Curve ;How Is the Deformation Computed ? The deformation is computed in each plane P, normal to the spine. By default the spine is the first reference curve, but you can select a new spine using the Spine field in the Reference tab. In each plane P, the system computes the intersection between the plane and each curve.A curve (Cr) is created between the first intersection point (Ir 1) and the last intersection point (Ir n) on reference curves, passing through all the intersection points between these two.Similarly, a curve (Ct) is created passing through all the intersections points between the first (It 1) and the last intersection point (It n) on target curves. Then, for each point Q, resulting from the intersection of the surface to be deformed with the plane, Q is projected onto the curve Cr according to the projection direction (dir). This projection direction is the vectorial product of: vector(lspine, lr2) ^ vector normal to P.The result of the projection of point Q is the point Qr, which parameter on Cr is v.Similarly, a point Qt is created on the curve Ct, with the same v parameter as point Qr on curve Cr . Then Qd, that is the transformation of point Q according to the wrap curve defor