柏显示喷雾拖把泵修理-ifixit.pdf

Rubbermaid Reveal pray Mop Pump Repair Rubbermaid Reveal Spray Mop Pump Repair Common problem with this great mop is the sprayer stops working. Problems with the handle trigger reveal (pun intended) an issue with the pump. Written By : Len © iFixit — CC BY-NC- A www.iFixit .com Page 1 of 7 Rubbermaid Reveal pray Mop Pump Repair INTRODUCTION This is a great design but with a crucial flaw. If you go to the Rubbermaid website and look at the Reveals user reviews mostly everyone loves the mop but has the same complaint - the unit stops spraying. Its often blamed on the handle/trigger but its actually the pump plunger/piston that binds and gets stuck in its cylinder. You will need to open the pump case and pull the assembly out. Once you get it out youll see its actually pretty simple with not many parts to worry about. It is a bit fussy to reassemble but not at all complicated. TOOLS: Long Phillips (star) screw driver with a small head. Very thin flathead screw driver. 120 grit sandpaper. (1) © iFixit — CC BY-NC- A www.iFixit .com Page 2 of 7 Rubbermaid Reveal pray Mop Pump Repair Step 1 — Determinin The Problem.  Trigger starts having problems - it sticks, returns slowly or wont return at all. No spray comes out of mop dispensing nozzle at base of pump chamber.  Notice in photo 2 the red pump casing sleeve and the tiny spray nozzle hole. Step 2 — Locatin The Pump Chamber Screws  You will need a long, thin, Phillips