本文pdf6619k-j-stage.pdfVIP

Vol. 16 No. 31 研 究 ワイヤ カ ッ ト放 電加工 の ワイ ヤ電極 挙動 に関す る研究(第2報) -ワ イ ヤ電 極 振動 の解 明- 堀 尾健 一郎* 木 下夏 夫** 福 井 雅 彦** Study of Wire Behaviour in Wire E. D. M. (2nd report -Explication of Wire Vibration- by Kenichiro HORIO, Natsuo KINOSHITA, Masahiko FUKUI General characteristic of wire vibration and the relationship between wire vibration and periodic discharge concentration in wire E. D. M. were investigated in the first report. In this report, more detail discussion of wire vibration in working gap were investigated. Following things are found. Periodic discharge concentration occurs a little earlier than wire comes close to workpiece, so it is estimated that bounding force caused by discharge concentration makes wire go away from workpiece. The existence of front gap, that means there exists workpiece in front of working direction, effects both forced vibration and free vibration. It causes forced vibration and extinction of normal mode vibration. Longer a point of wire apart from working gap, smaller the effect forced vibration at that point becomes and shorter the amplitude becomes. Wire vibration is expressed by the same formula as forced vibration of chord. And the component