shunt active and series active filters-based power quality conditioner for matrix converter分流活跃和积极filters-based电能质量调节器系列矩阵变换器.pdfVIP

Hindawi Publishing Corporation Advances in Power Electronics Volume 2011, Article ID 930196, 9 pages doi:10.1155/2011/930196 Research Article Shunt Active and Series Active Filters-Based Power Quality Conditioner for Matrix Converter P. Jeno Paul Department of Electrical and Electronics Engineering, Noorul Islam University, Tamilnadu 629001, India Correspondence should be addressed to P. Jeno Paul, jenopaul1@rediff Received 25 November 2010; Revised 2 February 2011; Accepted 6 May 2011 Academic Editor: King Jet Tseng Copyright © 2011 P. Jeno Paul. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This paper proposes a series active filter and shunt active filter to minimize the power quality impact present in matrix converters instead of passive filter. A matrix converter produces significant harmonics and nonstandard frequency components into load. The proposed system compensates the sag and swell problems efficiently in matrix converter. The proposed system has been tested and validated on the matrix converter using MATLAB/Simulink software. Simulated results confirm that the active power filters can maintain high performance for matrix converter. 1. Introduction bidirectional switches exist and the discrete unidirectional devices are arranged. So it can be used for each bidirectional Power quality is a set of limits or conditions of electrical switch. The matrix converter consists of 9 bi-directional properties that allows electrical devices to function in their switches [4] t