参考文献串567-89101131529116141625177.docVIP

  • 3
  • 0
  • 约1.01万字
  • 约 10页
  • 2017-08-30 发布于天津
  • 举报
参考文献串567-89101131529116141625177

三电平结构SVG输出电流谐波分析及滤波器设计 李元正,陈劲操,马炳洲,孙瑜 (南京理工大学 能源与动力工程学院,南京 210094) 摘要:研究三电平静止无功发生器主电路结构与调制方法。对三电平SVG输出电流谐波与纹波电流进行分析并利用双重傅里叶变换推导出三电平SVG输出电流公式并计算输出电流纹波。通过对输出电流纹波的计算,可以知道在达到相同电流纹波要求的情况下,三电平SVG输出滤波器逆变器侧电感值仅需要二电平时的2/3。在此基础上根据装置无功补偿能力、谐波抑制要求以及三电平SVG输出电流特点提出一种三电平SVG输出滤波器设计方法,使其在满足无功补偿能力的前提下,采用较小的电感实现较好的滤波效果。最后通过仿真与实验证明提出的设计方法的可行性。 关键词:SVG;三电平;谐波分析;输出滤波器 中图分类号:TM714.3 文献标识码:B 文章编号:1001-1390(2017)00-0000-00 Harmonic analysis and filter design for three-level SVG Li Yuanzheng, Chen Jincao, Ma Bingzhou, Sun Yu (Energy and Power Engineering College,Nanjing University of Science and Technology,Nanjing 210094,China) Abstract: In this paper, the main circuit structure and modulation method of three-level static var generator (SVG) is studied. Output harmonic current and ripple current of three-level SVG are analyzed and the formula of output current of three-level inverter is given by use of double Fourier tools. Through the calculation of the output ripple current, it is known that the inductance of the inverter side needed for a three-level SVG is only 2/3 of that for a two-level SVG to achieve the same current ripple. A design method for three-level static var generator (SVG) is proposed based on the reactive power compensation ability, harmonic suppression requirements of the equipment and the characteristics of the output current of the three-level SVG. Some parameters are designed for better filtering effect with relative small inductance under the premise of meeting requirements of reactive power compensation ability. Finally, the feasibility of the proposed design method is demonstrated by simulation and experiment. Keywords: SVG, three-level, harmonic analysis, output filter 0 引 言 静止无功发生器(SVG)通过控制逆变器中电力电子器件进行工作,因此其输出会不可避免的含有谐波成分,而大量谐波进入电网会导致电网电压、电流波形发生畸变,影响电网的稳定运行。因此,必须对SVG装置网侧接入滤波器后才能使其接入电网。 目前,对SVG的研究主要集中在主电路拓扑结构和控制算法方面[1-4]。文献[5]提出装置中选择滤波器方法,并没有提出相应的设计方法。文献[6-9]在仿真数据的基础上总结出多电平PWM 波形的谐波特点并提出了输出滤波器设计方法,但其仅仅依靠仿真分析说明,缺乏足够的理论推导,而且逆变器输出滤波器设计方法并不适合直接用于SVG输出滤波

文档评论(0)

1亿VIP精品文档

相关文档