反镗孔程序设计（Reverse boring program design）.docVIP

反镗孔程序设计（Reverse boring program design） 3., the program design process and some problems should be noted As mentioned above, two pause instructions shall be executed respectively when the tool is extended and the process is complete, so as to manually open and retract the tool. In general, the commonly used suspension are mainly G04 and M0, the former can be achieved by setting a pause time machine to suspend, arrival time, automatic recovery machine running behind the implementation of program instructions; the latter is adopted in the program to a certain extent a separate set of M0 instruction, this program is running when machine stops running the instruction, no time limit, if we do not perform other operations, the machine tool always suspend the implementation of action in the program, if the machine is to press the machine to resume operation cycle start button, the machine recovery operation, continue behind the program. Taking into account the manual opening and retracting the tool, the elapsed time is difficult to determine, to proficiency according to different operators and, and the cutter after long-term use of locking screws or tools will appear sliding and so on, are likely to make the tool in the machine pauses within the prescribed time does not meet the requirements of the state, at this time, if the machine action is likely to cause accidents greatly. Therefore, setting the pause instruction in the program, should first consider the use of the M0 instruction, the operator complete open and retract the tool, press the cycle start button, the machine can perform back processing procedures, the implementation of the processing operation. In order to further improve the safety of the cutting process can be two orders of mixed use, add a G04 program, in the M0 program after that, even if the operator in the press the cycle start, you can also have some time to observe the cutting tool, workpiece and machine tool, in order to find the problems, if there