Gear Test Rig A Review IJENS（齿轮试验台ijen重新评估）.pdf

International Journal of Mechanical Mechatronics Engineering IJMME-IJENS Vol:14 No:05 16 Gear Test Rig - A Review 1 2 3 4 A. P. Arun* , A.P.Senthil kumar , B. Giriraj , A. Faizur rahaman 1Department of Mechanical Engineering, Kumaraguru College of Technology, Coimbatore - 641049, India. *arunnical@ 2,3Department of Mechanical Engineering, PSG College of Technology, Coimbatore-641004, India. giri_4656@ 4Department of Mechanical Engineering, CSI College of Engineering, Nilgiris-643215, India. faizurmech@ Abstract-- In the past decades, many impressive progress had gears under controlled environment is needed. A simple been made in the field of simulation and analysis, even though construction of a test rig is shown in Fig. 1 which consists of experiments are necessary in many fields to conduct investigation a prime mover (motor), loading device (brake, dynamo meter, on mechanical components [26]. Gears are one of the such pump, etc.) and the test gear box which is to be mounted components that needed to be tested experimentally. Therefore, between the prime mover and loading device. test rigs are required with the possibility of varying speed and torque during the test, based on the requirement. In this paper, development of test rigs for evaluating the performance of gear has been studied. The main objective of this paper is to give researchers an