Installation and Operation Instructions （安装和操作说明）.pdfVIP

Peerless Pump Company PJPC Jockey Pump Controllers Installation and Operation Instructions Peerless Pump Company 2005 Dr. M. L. King Jr. Street Indianapolis, IN 46202 Bulletin 4857341 Rev. December 21, 2005 PJPC Instructions Jockey Pump Controllers WARNING! DO NOT ATTEMPT TO INSTALL OR PERFORM MAINTENANCE ON EQUIPMENT WHILE IT IS ENERGIZED! DEATH, PERSONAL INJURY, OR SUBSTANTIAL PROPERTY DAMAGE MAY RESULT FROM CONTACT WITH ENERGIZED EQUIPMENT. ALWAYS VERIFY THAT NO VOLTAGE IS PRESENT BEFORE PROCEEDING, AND ALWAYS FOLLOW GENERALLY ACCEPTED SAFETY PROCEDURES. JOCKEY PUMP CONTROLLER CIRCUIT BREAKER ON-OFF SWITCH MUST BE IN THE OFF POSITION TO OPEN THE ENCLOSURE DOOR. PEERLESS PUMP COMPANY CANNOT BE LIABLE FOR ANY MISAPPLICATION OR INCORRECT INSTALLATION OF ITS PRODUCTS. MOUNTING CONTROLLER NOTE - Consult the appropriate job plans to determine the controller mounting location. Tools and materials (wall mounting) required: 1. Assortment of common hand tools of the type used to service electromechanical equipment. 2. Drill for drilling wall anchor holes. 3. Hand level. 4. Tape Measure. 5. Four anchors with bolts and washers, per enclosure. 6. ¼ end wrench for adj usting pressure switch on-off and differential settings. MAKING ELECTRICAL CONNECTIONS IMPORTANT PRECAUTIONS. Prior to mounting the controller and making any field connections: 1. Verify that the following information is compatible with other related equipment on the project: A. Motor horsepower, voltage, phase and frequency. (See Page 5) B. System pressure 2. The project electrical contractor must supply all necessary wiring for field