SEAT BELT Installation Manual Jegs High （安全带安装手册联合工作组）.pdf

SEAT BELT Installation Manual You have purchase a premium set of Simpson Seat Belts. They are designed with attention to detail, just like your entire Simpson safety system. WARNING: THIS ARTICLE IS SOLD WITHOUT WARRANTY, EXPRESSED OR IMPLIED. NO WARRANTY OR REPRESENTATION IS MADE AS TO THIS PRODUCTS ABILITY TO PROTECT THE USER FROM ANY INJURY OR DEATH. THE USER ASSUMES THAT RISK. 1 1-800-731-4404 Version 1 ( +10 / -10 deg ) Figure 1: Shoulder and Lap Belt Mounting Zones – Upright Seating Position The Lap Belts should be mounted off the center of the drivers’ hip at an angle of 45 to 65 degrees down from the horizontal. (see Figure 1) All seat belt mounts need to be as close to the seat system as possible. In some cases, it is advantageous to mount the belts inside the seat. The lap belts should be mounted with a double shear type mount and the lap anchor should be allowed to rotate freely. It is advantageous to have the Pull Up style adjuster on the lap belt inside the seat, just on top of the leg radius. Custom size anchors can be ordered to facilitate this. In some cases, this may not be a viable option because of driver size. If this is the case, the adjuster must be mounted outside the seat with a short pull up mount . The path that the lap belt takes from the anchor to the buckle must be free of obstruction. If the belt routes through a seat opening, it must allow for the belt to rotate forward by at least 30 degrees without being cut or frayed. The lap belt mount needs to have a secure anchor to the chassis or frame of the vehicle. The mount should b