Spherical washers and conical seats 6319 （6319年球面垫圈和锥形席位）.pdf

DEUTSCHE NORM October 2001 Spherical washers and conical seats 6319 ICS 21.060.30 Supersedes October 1997 edition. Kugelscheiben, Kegelpfannen In keeping with current practice in standards published by the International Organization for Standardization (ISO), a comma has been used throughout as the decimal marker. Foreword This standard has been prepared by Technical Committee Grundnormen für Spannzeuge und Vorrichtungen of the Normenausschuss Werkzeuge und Spannzeuge (Tools and Clamping Devices Standards Committee). Amendments This standard differs from the October 1997 edition in that it has been editorially revised and the specifica- tions for surface roughness and hardness have been amended. Previous editions DIN 6333: 1940-05; DIN 6319: 1935-08, 1944x-07, 1963-04, 1987-04, 1991-09, 1997-10. All dimensions are in millimetres. 1 Scope This standard specifies dimensions, the material and design of spherical washers and conical seats. These elements are designed to accommodate bolting forces where such are needed to compensate for clamping faces that are not parallel. Use of spherical washers together with conical seats permits bolts to be inclined up to 3° relative to the axis of the assembly. For slots, such as those in clamps covered in DIN 6314, DIN 6315 and DIN 6316, only type G conical seats shall be used, whilst type D