T12U UNIVERSAL BACKTOBACK GEAR TEST （T12U普遍BACKTOBACK齿轮测试）.pdfVIP

T-12U UNIVERSAL T-12U UNIVERSAL T-12U UNIVERSAL BACK-TO-BACK GEAR TEST RIG BACK-TO-BACK GEAR TEST RIG BACK-TO-BACK GEAR TEST RIG FOR TESTING OF SCUFFING, PITTING AND MICROPITTING OF LUBRICATED GEARS ul. K. Pulaskiego 6/10, 26-600 Radom, POLAND fax: (+48-48) 3644765 www.it .radom.pl www. trib-dep@it .radom.pl CHARACTERISTIC OF T-12U UNIVERSAL GEAR TEST RIG T-12U Universal Gear Test Rig is intended for testing of an effect of lubricants on scuffing of gears, and optionally, pitting and micropitting. The basic version of T-12U machine is intended for performing FZG scuffing test methods: −− A/8.3/90 according to: ISO 14635-1, CEC L-07-A-95, DIN 51354, IP 334, ASTM D 5182, PN-78/C-04169. −− −− A10/16.6R/120 for high EP oils according to ISO 14635-2 and CEC L-84-02. −− −− S-A10/16.6R/110 for GL-4 and GL-5 gear oils according to FVA Information Sheet No. 243 (2000). −− −− A/2.8/50 for semifluid gear greases according to ISO 14635-3. −− R The tribosystem consists of a pair of special gears (pinion and gear wheel), known as FZG type “A” gears, loaded at the required torque and rotating at the defined speed. The gears are case-hardened, Maag-Cross hatch ground. The effective tooth width of the pinion is either 20 mm (type “A”) or 10 mm (type “A10”). The motor rotates clockwise or anti-clockwise (reverse - “R”), depending on the test method performed. The test gears are inserted in the chamber equipped with the heater which enables to raise the temperature of the tested oil before the run. T-12U Univ