点火器与电磁阀故障判断（Ignition and solenoid valve fault diagnosis）.docVIP

下载本文档

4
0
约6.17千字
约 5页
2017-09-02 发布于河南
举报
版权申诉

点火器与电磁阀故障判断（Ignition and solenoid valve fault diagnosis）.doc

1、本文档共5页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
5、该文档为VIP文档，如果想要下载，成为VIP会员后，下载免费。
6、成为VIP后，下载本文档将扣除1次下载权益。下载后，不支持退款、换文档。如有疑问请联系我们。
7、成为VIP后，您将拥有八大权益，权益包括：VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
8、VIP文档为合作方或网友上传，每下载1次，网站将根据用户上传文档的质量评分、类型等，对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档

点火器与电磁阀故障判断（Ignition and solenoid valve fault diagnosis）

点火器与电磁阀故障判断（Ignition and solenoid valve fault diagnosis） * * * water heater has a fire, but not flammable, check the ignition to the solenoid valve in the 3 lines, the outer two lines have 3 volts, the middle and the outside of a 0 volts, ignition problems, * * *? 2011-11-09 21:06 questions: zmtbt| browse times: 740 times The other off line, with the solenoid valve with two batteries, not connected with two lateral lines, a middle and a movable lateral root, (re wiring untouched), resistance of electromagnetic valve: a middle and outer root between the 6 in Europe, two lateral line resistance is infinite, electromagnetic the valve has a problem? Let me help him with that Recommended answer 2011-11-09 21:18 As the landlord said, solenoid valve failure, replacement can be, solenoid valve three lines, Gong, run, start. Start operation and start line at the same time power supply, pull in after the starting line power off, you measure when the running state, so there are only two lines have voltage, I have repaired more than N, this kind of water heater, do not understand, welcome to ask me Thank you for asking HEHONG style help, Ill try to do it, the other in the measurement of ignition loss to the solenoid valve 3 lines, two lateral lines have 3 volts, the middle and lateral one from the beginning has been to 0 volts, namely a middle (estimated starting line) start without voltage. The igniter has the problem? Hope to get advice! Answer landlord, the ignition is generally not bad, unless the water, and we have 60 water heaters, five years, I have never repaired an ignition is bad, solenoid valve is not easy to bad, relative to the ignition device. Easier problems, but also to repair is often overlooked, is high gas pressure, resulting in solenoid valve does not open, valve failure rate is relatively high, the landlord has lighter voice if so, turn off the gas, remove the solenoid valve, hand gently push a little inside rubber pad and then boiling water, ignition, see