热工 仪表高 计算（High calculation of thermal instrument）.docVIP

热工 仪表高 计算（High calculation of thermal instrument） Five. Calculation questions 1, there is a U tube pressure gauge, the distance between two liquid column S equal to 50mm, the liquid column for vertical tilt angle phi is 2 degrees, the position error of delta H (TG2 = 0.035). Solution: H = S * TG Phi = 50 x TG2 degrees = 1.7 (mm) Answer: the read position error is 1.7mm. 2. There is an industrial pressure gauge with an upper limit of 6MPa and an accuracy level of 1.5. The range and accuracy level of the standard pressure gauge used for this pressure meter shall be determined. Solution: the upper limit of measurement of the standard meter is the measurement upper limit * (4/3) of the school table = 6 x (4/3) = 8 (MPa) Selection range: 0 ~ 10MPa. Standard pressure gauge the accuracy of the detected meter accuracy is less than or equal to 1/3 * (detected meter cap / standard limit) = 1/3 * 1.5 * 6/10 = 0.3 A standard table with a precision of 0.25 is chosen. Answer: the range and accuracy levels of the standard pressure gauges used are 0 to 10MPa and 0.25 respectively. 3, with two standard platinum 10 platinum thermocouple calibration industrial nickel chromium - nickel silicon thermocouple, at 1000 DEG C, measured by the average value of the thermoelectric potential detection thermocouple is 40.580mV, using mercury thermometer measured reference end temperature is 20. The average reading standard thermocouple is 9.558mV, the value of standard thermocouple 0.025mV in the correction of 1000 DEG C, the reference temperature is 0 DEG C, by error and correction at 1000 DEG C. Thermocouple value is how much? Known EK (20, 0) = 0.798mV, EK (995.5, 0) = 41.093mV, ES (995.5, 0) = 9.533mV. Solution: calculate the corrected potential value of the standard thermocouple ES = 9.558+ (0.025) = 9.553 (mV) The corresponding temperature is 995.5 degrees from the known conditions, and also due to EK (20, 0) = 0.798mV. Therefore, when the reference temperature of the thermocouple is 0 deg