焊接试题（Welding questions）.doc

焊接试题（Welding questions） Test method for butt welding crack test belongs to welding hot crack (V). 2, when the plate thickness is less than or equal to 20mm, the thickness of the specimen shall be equal to the plate thickness (V). 3, as the thickness of the material, multilayer welding bending than single-layer welding high pass rate (V). 4, welding joint impact test, at the same time as the testing of welded joints of cold aging sensitivity (V). 5. The purpose of the flattening test is to determine the hardness of the welded butt joint of the pipe. 6, when high speed ions strike on the metal surface, X rays are produced on the surface of the metal. 7, a single point slag spots in the negative, irregular appearance, with edges, uniform density (V). The 8 is to rely on the medium and ultrasonic (V). 9, ultrasonic inspection of defects is intuitive (x). 10, fluorescence tests are used to detect certain ferromagnetic materials (x). The sensitivity of 11, is the test of the high fluorescence stain test (V). 12, examination of fracture is very sensitive to the fusion and fusion this defect (V). 13. Hydrogen can cause hot crack easily in welding joint. 14, remove the drying temperature of electrode adsorbed water is more than 100 DEG C (V). 15 deposited metal, chemical analysis of specimens dipped in water without the need for the water temperature (V). 16, check whether there is water leakage, leakage and seepage oil, oil spills and other phenomena of the test called pressure test (x). 17, the welder should generally be welders to complete the installation work (x). 18, the debugging process of plasma arc welding and cutting equipment must be in strict accordance with the rules of use (V). The 19 part of the inspection, welding and cutting equipment for plasma arc is no exception, in order to debug (V). FIG. 20 principle, welding and installation of circuit diagram is two electrical wiring diagram of welders and welding equipment repair personnel often used (V). 21, elect