Tolerances for Toughened, Annealed and （公差为钢化、退火和）.pdfVIP

Toughened Curved Glass Furnace Glass Thickness Maximum Girth Maximum Height Minimum Radius 1 5mm – 19mm 2550mm 3250mm 1000mm (may increase on thicker glass, subject to shape etc.) 2 6mm – 15mm 2400mm 4200mm 1500mm 3 6mm – 15mm 4200mm 2500mm 2500mm Annealed / Laminated Curved Glass  Maximum Angle 180°  Please note that on bends above 90° optical quality may be affected. Tolerances for Toughened, Annealed and Laminated Curved Glass Glass Thickness Tolerance 6mm – 12mm +/- 3mm 15mm +/- 4mm 19mm +/- 5mm Squareness Squareness is measured by comparison of diagonals  2000mm – 4mm  2000mm - 5mm Edgework All thicknesses of glass can be produced with the following edgework options:  Arrised  Ground  Polished Holes Diameter Diameter Tolerance Step Tolerance 6mm – 49.5mm +/- 0.5mm +/- 1mm 50mm – 99mm +/- 1mm +/- 1mm  Diameter of holes must be equal to thickness of glass  Hole Positions:  Measurement from the edge of glass to edge of hole must be no less than 1.5 times the thickness of the glass  Measurement from the corner of the glass to the edge of hole must be no less than 4 times the thickness of the glass. The tolerance for the hole centre position will be between +/- 1mm and +/- 3mm dependent on the glass size and thickness.