Ultrasonic Distance Measurement Module （超声波测距模块）.pdfVIP

Ultrasonic Distance Measurement Module - use a breadboard for connecting it to your Arduino (not shown in schematic below) - do not use higher than 5V as a supply voltage (“VCC” on sonar = pin for supply voltage) - verify module function with the Arduino Serial Monitor before implementing with your application Sample Code: // Very few comments in this code :( Can you figure it out anyways? // Does it work? If not, always compare your schematics with your // code: Can it work? Does it make sense? /* HC-SR04 Ping distance sensor] VCC to arduino 5v GND to arduino GND Echo to Ar