利用正交试验设计优选氰,莠水悬浮剂配方.pdf（Optimization of formulation of atrazine atrazine suspension by orthogonal design.Pdf）.docVIP

利用正交试验设计优选氰,莠水悬浮剂配方.pdf（Optimization of formulation of atrazine atrazine suspension by orthogonal design.Pdf） With the increase of amount of wetting dispersant, water Suspension viscosity decreased gradually, reaching a certain viscosity value, With the increase of the content, the viscosity gradually increased significantly, 3 kinds of wetting and dispersing agents have this phenomenon. Ning milk 33#, Emulsifier 12# and Ning 34# respectively in the mass fraction of milk There is a minimum value of 3%, 2.5% and 2% from the viscosity. And the determination of their dosage in the preparation. The Ning milk The amount of 33# is relatively high, so the choice of emulsifier 12# and 34# in the following test Ning milk. 2.3 choose Fig.I Re1ationship between viscosity regulator mass fracti0n 0f Carboxymethyl cellulose, polyvinyl alcohol, xanthan gum into the dispersant and viscosity of suspension For the screening, according to the amount of preparation and regulation of viscosity, considering the price, such as ease of dissolution, the final choice Xanthan gum as the best viscosity modifier. Taking into account the dispersant on the viscosity of preparation was also affected, reference single agent experience, indeed The quality score of xanthan gum in the preparation for the 0.1%. The screening results of 2.4 better formula The physical stability of the suspension is a technical difficulty, often with the extension of storage time and stratification, at the end of the current node Like, so agents will be configured at room temperature for 1 A and 2 a respectively after the preparation was determined by hierarchical rate and suspension rate, combined with external The concept of evaluation of the pros and cons of each formulation (see Table 3). The factors were stratified rate and suspension rate range analysis (see Figure 2). Comparison of 2 factors of the stratified range rate, nongru 500# (C factor) of the maximum range, indicating that the factor of stratified rate The