屋瓦面（Tile surface）.docVIP

屋瓦面（Tile surface） Construction plan of sloping roof hanging tile, 1. project overview: The roof of the project consists of flat roofs and sloping roofs with towers and tiger windows. The roof waterproof layer adopts two SBS modified asphalt waterproof coiled material, and the flat roof surface is made of fine stone concrete protection layer. The sloping roof waterproof layer with a SBS modified asphalt waterproof coiled material, the surface layer of flat tile roof. The drainage slope of flat roof is 2%, and the slope of drainage slope is 45 to 70 degrees. 2. construction sequence Slope roof: basic cleaning, sloping layer, leveling layer, waterproof layer, a smooth, sticky nail insulation board, nail batten, hanging tile, detail processing, inspection and acceptance, water test. Flat roof: basic cleaning, sloping layer, leveling layer, waterproof layer, insulation board, steel mesh, fine stone concrete and detail treatment, inspection and acceptance, caulking 3. main construction methods 3.1, find the slope layer (the thinnest 40 thick expansion cement perlite, slope) 3.1.1 mixing ratio: 1: 8 (cement: perlite) The quality, technical performance and mortar mixture ratio of the materials used in 3.1.2 must comply with the design requirements and specifications. 3.1.3 retention partition slot (and exhaust duct): 10 square 5m per square width, seam with 50PVC tube, the body around the hole, as the exhaust channel. The roof of the exhaust pipe with diameter 50PVC tube), leaving at the same time to do waterproof measures, exhaust hole height from 30 cm to the highest point on the roof. The pipe body is embedded in the roof part and is punched in the periphery. 3.1.4 the slope shall meet the design requirements. 3.2 leveling layer (25 (20, 15) thick 1: 3 cement mortar leveling layer) 3.2.1 operating conditions First, the basic level (for slope) shall be checked and accepted by concealed works, and the leveling layer shall be constructed before qualified. The drainage slope