analysis of the substation operation and management of risk and prevention methods point（分析变电站的操作和管理的风险和预防方法）.doc

Analysis of the substation operation and management of risk and prevention methods point Paper Keywords: substation operation management point to prevent dangerous Abstract: As China continues to accelerate the pace of socialist modernization construction, substation operation work has become an extremely important project of the current face of the substation after the operation and management of potential threats that we must do a comprehensive analysis. Thus, the attendant need to be taken in substation operation error to a minimum, so you can maintain the normal operation of the grid. On this point, this case to specific project targeted to run on the existing substation conducted a comprehensive analysis of security risks to develop a scientific maintenance program. A substation operation management, there are several danger points 1.1 Transformer operation Duty personnel must ensure that when the transformer high degree of caution, as long as part of a small error can cause significant adverse effects normal state, the personnel to operate the transformer when the most dangerous points presented in two forms: first, to meet load Most occur when the transformer over-voltage problems, these functions will cause damage to the insulation transformer; Secondly, the transformer no-load voltage is increasing, and this will also damage the transformer insulation damage. These are to remind the operator transformer must be for the attention of the entire operation. 1.2 bus switching operation Bus switching operation for switching operation is very important in terms of composition, if the operator is not sufficient preparation for the work, also failed when the procedure is strictly based on the standard operation, the probability of the existence of risk will continue to grow. The bus switching operation also has a different form when the danger point, there is one problem with negative Hera Knife, the second is due to switch relay and automatic