48伏电瓶车充电器原理（Charger principle of 48 volt battery car）.docVIP

下载本文档

11
0
约1.29万字
约 8页
2017-09-05 发布于河南
举报
版权申诉

48伏电瓶车充电器原理（Charger principle of 48 volt battery car）.doc

1、本文档共8页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
5、该文档为VIP文档，如果想要下载，成为VIP会员后，下载免费。
6、成为VIP后，下载本文档将扣除1次下载权益。下载后，不支持退款、换文档。如有疑问请联系我们。
7、成为VIP后，您将拥有八大权益，权益包括：VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
8、VIP文档为合作方或网友上传，每下载1次，网站将根据用户上传文档的质量评分、类型等，对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档

48伏电瓶车充电器原理（Charger principle of 48 volt battery car）

48伏电瓶车充电器原理（Charger principle of 48 volt battery car） At present, the most widely used, is also one of the earliest can directly drive the single end drive MOS FET switch to MC3842. MC3842 in the stable output voltage at the same time, also has the control function of the load current, which is often called the current mode switching power charger for drive, undoubtedly this function has a unique advantage, only a few external components can achieve constant voltage output, and can control the charging current. Especially MC3842 can directly drive the MOS characteristics of FET tube, greatly improve the reliability of the charger can be. Because MC3842 is widely used, this paper introduces its characteristics. MC3842 as the excitation switching power supply of double row 8 foot single ended output driver circuit, the internal function includes a reference voltage regulator, error amplifier, pulse width comparator, latch, oscillator, pulse width modulator (PWM), pulse output driver etc.. MC3842 more similar products, including UC3842, IR3842N, exchangeable SG3842, CM3842 and LM3842 (domestic). Inside the MC3842 block diagram shown in figure 1. Its characteristics are as follows: Single PWM pulse output, current output drivers for 200mA, peak current up to 1A. Start voltage is greater than 16V, the starting current is only 1mA to enter the working state. Enter the working state, the working voltage between 10 ~ 34V, the load current is 15mA. More than the normal working voltage, switching power supply into undervoltage or overvoltage protection, the integrated circuit without driving pulse output. 5V/50mA internal reference voltage source, the partial pressure of 2:1 as the reference voltage sampling. The output of the driving pulse can drive the bipolar transistor, it can also drive the MOS fet. If the drive transistor, should be the base access switch RC cut-off circuit at the same time will be accelerated, the oscillator frequency limit below 40kHz. If the driver M