cad尺寸标注命令（CAD dimension command）.docVIP

cad尺寸标注命令（CAD dimension command） Dimension command 2009-10-15 11:31:00| classification: blue | Tags: | name and subscription. A new text style 1. call (1) command line: STYLE (2): format, text style menu Using any of the methods above, display as shown in the text style of dialogue Click the new button to display as shown in the new text style dialog and click OK button to set up a new text style name. Two, set the font name and height (1) select the font name in the font name list, determine the font height (if you write a single line of text in the command window, can enter the word, high) users can choose according to the fonts (2) click the apply button, click the close button (recommended TT font font design Chinese characters GB2312) Three, special characters Writing in the graph, in addition to input characters, numbers and English Chinese characters and symbols commonly used.AutoAD2004 also provides control code and some special characters. If the diameter of symbols, round degree symbol, positive and negative tolerance symbol etc.. These symbols can not be directly from the keyboard input, to use the control code, control code is defined as shown in the table. Four, multiple lines of text annotation and editing There are two kinds of input text: one is to use Text and Dtext command input text line to the graph; the other one is to use the Mtext command (i.e. multiline text editor) input text line to the graph. The operation method of two kinds of command and the Mtext command will be similar to the text as an object, especially suitable for processing the paragraphs, its function is far than the Text and Dtext commands more powerful and flexible, therefore, here only introduce multiple lines of text input. 1, start command: (1) command Mtext (2) drawing menu in the drawing menu select text menu multiple lines of text commands. Click the toolbar in the Drawing toolbar icons 2, note: Mtext command system Current text style: current style. Text height: current