光电检测器（Photoelectric detector）.docVIP

光电检测器（Photoelectric detector） In DWDM system, laser wavelength stabilization is a very critical issue, according to the ITU-T recommendations of G.692, plus or minus 1/5 deviation is not greater than the center wavelength of the optical channel spacing, i.e. when the optical channel spacing of 0.8nm system, deviation of not more than 20GHz wavelength. In the DWDM system, because of the light path interval is very small (as low as 0.8nm), and the wavelength stability of the light source have strict requirements, such as wavelength change of 0.5nm is enough to make a light path to another optical path. In the actual system usually must be controlled within 0.2nm, the specific requirements vary with wavelength interval, the wavelength interval is smaller higher demands, so the need to adopt laser wavelength stabilization technique strictly. Integrated electro absorption modulated laser wavelength tuning is mainly realized by changing the temperature, the temperature sensitivity of the wavelength is 0.08nm/ Deg. C, normal working temperature is 25 DEG C, adjusting the chip temperature at 15 DEG -35 DEG temperature within the range of EML can be adjusted in a specified wavelength, adjust the range of 1.6nm. Adjusting the driving current by changing the temperature of the chip cooler, and thermistor for feedback can make the chip temperature stable at a constant temperature. Distributed feedback (DFB) laser wavelength stability is based on the characteristics of the wavelength and the temperature corresponding to the tube core, by controlling the laser tube core temperature to control the wavelength, in order to achieve the purpose of stabilizing the wavelength. For the 1.5 m DFB laser wavelength, temperature coefficient of about 0.02nm/ DEG C, it at 15 DEG -35 DEG range to meet the requirements of the central wavelength. The temperature of tube core temperature feedback control method depends entirely on DFB laser. At present, MWQ-DFB laser technology in the life time of