内存解说（Memory commentary）.docVIP

内存解说（Memory commentary） One of the most important properties of a set of standard memory. What is the meaning of this? In fact, it is not difficult to understand, but also very easy to calculate. The total memory bandwidth we have just said is actually in the ideal state of this group in the memory capacity of a maximum data transmission to seconds. The formula is simple: the total memory bandwidth (MBytes) = maximum clock speed frequency (MHz) x (bits) x bus width per clock data segment number / 8 Well, we have to explain it. Each data segment number is always the best understanding, you only need to remember, if your memory is SDR here so this value is equal to 1, if you are using DDR or RDRAM, then this value is 2. We then will this value divided by 8 is the unit conversion into byte. So, for the general standard of PC2100 DDR memory, his maximum clock frequency is 133MHz, while the memory bus width is 64bit, each clock data segment number is 2. So, (133x64x2) /8 = 2128MB/s. A second can transfer 2128MB, now you know why it is called PC2100? Another example. Take the PC800 RDRAM to calculate. The maximum clock frequency is 400MHz, the memory bus width is 16bit, each clock data segment number is 2, then apply the formula is (400x16x2) /8 = 1600MB/s. From here you can see it, PC2100 DDR memory can provide up to 2.1GB/s bandwidth and RDRAM memory bandwidth can only reach 1.6GB/s, but we need to pay attention, because the RDRAM is used to use two memory a total 3.2GB/s memory bandwidth, and a new generation of RIMM (memory bus 32 bit RDRAM memory) will use two data channels, so their bandwidth under a doubled, this will become the 3.2GB/s, and a memory can be used alone. Memory clock First of all I want to give you the reason that the memory performance is not only the speed of data transmission by its decision. The memory from the received request to respond to this request is to determine the performance of memory is a very important factor. And now most of the mem