去耦等效电路法在分析耦合电感电路中的运用（The application of decoupling equivalent circuit method in analysis of coupled inductance circuit）.docVIP

去耦等效电路法在分析耦合电感电路中的运用（The application of decoupling equivalent circuit method in analysis of coupled inductance circuit） Decoupling equivalent circuit method in the analysis using the coupled inductor in the circuit Yan Shaoxing, Cui Jing 1. introduction The analysis of linear inductive coupling circuit, must consider the effect of mutual inductance coupling inductor. Therefore this kind of circuit analysis method for different treatment on the mutual effect and different. General connection mode coupled inductor as two mutual branch and: If the coupling inductor in series, two series transformer branch. Using the series equivalent formula of coupling inductance, the coupled electric influence into an inductive component L, which L=L1+L2 + 2M If the mutual inductance coupling inductance parallel, two parallel branches. Using the parallel equivalent formula of coupling inductance, can also be coupled to a power effect inductive element L, which If one end is connected to two coupled inductor, transformer branch with a common node, using the decoupling equivalent circuit method (also known as the method of eliminating mutual inductance), equivalent T network will use three coupled inductor inductor replacement. If the coupling inductance in the circuit belongs to the three connection form, in the analysis of the circuit, you can use the above method respectively, the coupled inductor equivalent circuit for an inductive element or a three inductor in T network. This circuit can be used as a general non mutual inductance circuit to calculate. If the coupling inductance without connection, namely two mutual branch connecting points (no hollow transformer), because this kind of coupled inductor cannot be replaced by an equivalent network inductance L or a T, these methods cannot be used in the analysis of hollow electric transformer The road. Because of the mutual effect depends on the increase in the voltage source circuit to meter and the analysis can be solved by using