优盘修复知识（USB repair knowledge）.docVIP

优盘修复知识（USB repair knowledge） I found the file recovery method for bad U disk repair and damaged U disk on the internet. Hope to inspire you: About the bad U disk repair and damage U disk file recovery method, probably a lot of people know, but here I want to mention again, his U disk is broken, several times have repaired. After a few of my U disk repair experience, and some information on the Internet, I summed up the following content. Generally, U disk faults are classified into soft and hard faults, among which soft faults are the most common. Soft fault mainly refers to the U disk has bad blocks, resulting in U disk can be computer recognition, but no letter, or a letter, but when you open the U disk is prompted to format and format, and can not be successful. Early symptoms may include: U disk read and write slowly, the file is lost, but still occupy space. The bad U disk can generally be through software self repair, the self repair tool commonly used with Mformat (you can go online to search and download, convenient use, less than a minute, of course some repair) U disk manufacturers will also provide some similar software. I believe that since it is low, the fault type is the same, should drive low grid tools can also be used in Lformat, but because Lformat is running under DOS, relatively trouble, and I also did not specifically tried, it is not recommended. Hard fault mainly refers to the U disk hardware failure, plug in the U disk and the computer will find new hardware, but can not drive, open the U disk without any circuit board burn out or other signs of damage, and the application method of soft fault can not solve the situation. (I long ago there was a U disk, because not letter, to customer service service department for maintenance, because I also look at the scene, they inserted a long time, even did not try a soft recovery, said it was impossible to repair, just to change a piece, rejoicing, but also show these people ignorance). The hard fault