总线协议（bus protocol）.docVIP

总线协议（bus protocol） Socket, like its English language, is like a porous socket. A host is like a room full of sockets, each with a number, some sockets with 220 volts alternating current, some with 110 volt alternating current, and others with cable programming. Customer Software plugs into different numbers of sockets and gets different services. (4) RS232 Data transfer between computer and computer or computer can be done in two ways: serial communication and parallel communication. Because the serial communication mode has less use and low cost, it is widely used in remote transmission, avoiding the inconsistency of many line characteristics. In serial communication, both sides of the communication are required to adopt a standard interface, so that different devices can be easily connected to communicate. RS-232-C interface (also called EIA RS-232-C) is the most commonly used serial communication interface at present. It was developed in 1970 by the United States Electronic Industry Association (EIA), a joint Baer system, modem manufacturer and computer terminal manufacturer, and developed standards for serial communications. Its full name is data terminal equipment (DTE) and the data communications equipment (DCE) between the serial binary data exchange interface technology standard DB25 connector of the standard requires the use of a 25 foot, the signal content for each of the pin connector to be provided, also on the level of avariety of signals to be provided. (5) RS-485 RS-485 is a two-way and half duplex communication protocol that allows multiple drives and receivers to be attached to the bus, each of which can be detached from the bus. This specification meets all RS-422 requirements and is more stable than RS-422. Has higher receiver input impedance and wider common mode range (-7V to +12V). The receiver input sensitivity is + 200mV, which means that if the symbol or interval state is to be identified, the receiver voltage must be higher than +200mV or b