直流锅炉（Direct current boiler）.docVIP

直流锅炉（Direct current boiler） Two 、 operation control of direct current furnace (a) DC boiler steam pressure control The unit load increases when the turbine valve open, steam flow increases immediately, which also immediately increase turbine power. As the feed water flow rate and combustion rate of the boiler have not changed, the temporary increase of steam flow and steam turbine power is due to the decrease of steam pressure and the thermal storage of the boiler. Due to the small storage capacity of the direct current boiler, the rate of pressure drop is greater. After the stable pressure maintained at low values. (two) steam temperature control of once through boiler As a drum boiler, the direct current boiler can separate the evaporating heating surface from the superheater. Because of the single change characteristics of the feed water and the fuel, the steam temperature will be obviously affected. We must keep fuel water ratio unchanged, but even to ensure the fuel water ratio as the basic means, the temperature of superheater between often still need to reduce water temperature, in order to meet the need of regulating steam superheater changes under the condition of moderate protection. In operation, the water pressure regulating valve should be opened at the middle position, so as to change the working conditions, not only big but also small. Therefore, the basic measure of the steam temperature control of the direct current boiler is to maintain the water to fuel ratio, and the water injection temperature reduction is only a temporary measure. By controlling the temperature at the middle point unchanged, the temperature of the steam varies steadily. The reheater temperature is controlled by the tail flue flue gas damper and the cold re entry accident, and the first stage water injection is used to reduce the temperature. The main influencing factors are the steam temperature at the outlet of the reheater, the change rate of the unit load, the water jet temp