自行车维护（Bicycle maintenance）.docVIP

自行车维护（Bicycle maintenance） Bicycle maintenance.Txt49 rocks because of conviction, it aroused the beautiful waves; youth because of the pursuit of lofty, only exceptionally bright and colorful. 50 because young, so self-confidence; because of self-confidence, so young. Bicycle maintenance Verse 1 Specifications and requirements for bicycles As a race bike, first, must be to promote human; second, not with any wind (reducing air resistance) equipment, but can be installed in transmission; third, the bicycle is not more than 2 meters long, not more than 75 cm, and the ground for 24 - axis distance of 30 cm, axis to the front axle distance of 58 - 75 cm, the distance between the centre shaft and the rear axle of not less than 55 cm, the front seat in the vertical axis after not exceeding 12 cm. Handle width not less than 75 cm. The wheel diameter, the saddle and the frame form can be selected by themselves. In order to ensure the safety of athletes, road racing must be flexible performance, front and rear brakes are effective, with rubber or cork plug the handlebar pipe head. There must be no sharp parts on the car, and the screws must not stand out. Second quarter Check the components of the bicycle in good condition Bicycle should be cleaned regularly and kept clean. Wipe the bike with 50% of the oil and 50% of the gasoline as a detergent. Only when the car is wiped clean can the fault of each part be found in time and the repair is ensured to ensure the smooth progress of training and competition. Every day an athlete should wipe his car. By cleaning, the bicycle can not only maintain the cleanness and beauty of the bicycle, but also help to check the intact condition of each part of the bicycle, and cultivate the sense of responsibility and dedication of the athletes. Inspection vehicles should pay attention to: the frame, fork and other parts of the cracks and deformation can not be, the various parts of the screws to tight family, handlebar flexible rotation. Each