郑州旋挖钻机减速器的合理维护修理（Reasonable maintenance and repair of speed reducer for rotary drilling rig in Zhengzhou）.docVIP

郑州旋挖钻机减速器的合理维护修理（Reasonable maintenance and repair of speed reducer for rotary drilling rig in Zhengzhou） Reasonable maintenance and repair of speed reducer for rotary drilling rig in Zhengzhou The power head reducer of rotary drilling rig is one of the key parts in the use process. The working state of the reducer directly affects the performance of the main engine, so it should be properly maintained and repaired. 1. maintenance points (1) lubricating oil level; Because of the internal gear reducer, bearings and other parts in the work of high-speed rotation, so the moving parts must ensure the lubrication can get adequate and clean during exercise, otherwise the transmission part will cause premature failure, paralysis of the system. In the use of the process should always pay attention to the reducer oil level and the cleaning of lubricating oil. When the oil level is lower than the regulation, it should be added immediately. When the lubricant is too dirty, it should be replaced in time. (2) the temperature of lubricating oil; When the reducer is in high temperature in summer or the continuous output power is large, the oil temperature will be high. When lubricating oil is over 100 degrees centigrade, its lubricating property and film quality are obviously reduced, which will lead to the wear of gear and bearing in gear reducer, and the early pitting of gear will affect the service life. At this point, it can use high grade lubricating oil and shorten the oil cycle, or through an oil pipe in the two plug position increases, forced circulation cooling and lubricating oil solution. During the winter construction, the environment temperature is low. When the system starts to work, the oil temperature of the reducer is very low. When lubricating oil is lower than 0 degrees centigrade, its lubricating property drops obviously. At this point, you can increase the temperature of the lubricating oil by heating the reducer lubricant, or load it for a period of time befo