allegro心得体会（Allegro experience）.docVIP

allegro心得体会（Allegro experience） The setting sun is infinitely good, just near dusk. Who grass inch heart, reported in the apartments. Mountain of koetsu birds, energy-saving. Jujiu cage, in the river. A quiet and modest maiden, a gentlemans good mate. Thirty fame dust and soil, eight thousand miles. ALLEGRO learning experience Software version: Allegro SPB 15.5 Schematic diagram 1. establish the project Like other graphics software, OrCAD manages various design documents with Project. Click the start menu, and then all the programs -- -- Allegro SPB 15.5--Design Entry CIS, in the pop-up Studio Suite Selection dialog box, select the first item OrCAD_Capture_CIS_option with capture, click Ok to enter Capture CIS. Next is File--New--Project, in In the pop-up dialog box, fill in the name of the project, path, and so on, click Ok to enter the design interface. 2. schematic drawing After the new project opens, the default schematic file SCHEMATIC1 PAGE1, with the toolbar on the right, is used to place elements, draw lines and add nets And so on, the usage is similar to that of Protel. Click the Project manager on the upper toolbar (folder tree icon) to enter the project management interface, Here you can modify schematics, file name, settings, drawings, Zhang size and add principle library, and so on. 1) modify the principle drawing size: Double click the SCHEMATIC1 folder, right-click PAGE1, select Schematic1 Page Properties, and select the option in the Page Size Bits, sizes, etc; 2) add principle library: File--New--Library, you can see in the Library folder more than one library1.olb principle library file, right-click this File, select Save, rename, save; 3) add new components: Common components come with their own (e.g. resistors, capacitors), and often do their own components, or use other people to do the components. Right click Click the new OLB library file you just created, select New Part, or New Part From Spreadsheet, which creates a new form in tabular form