protel dxp复习题（protel dxp复习题）.docVIP

protel dxp复习题（protel dxp复习题） 1. The basic process of schematic design. (1) start the Protel DXP schematic editor: execute the File-new-Schematic command, you can open the schematic editor. (2) set up the size and layout of the circuit schematic. (3) the required components are removed from the component library and placed at the working plane. (4) connecting components according to the design requirements. (5) adjust the components after the layout. (6) save the drawn schematic document. 2, in the process of placing wires, press the Shift+Space button to switch the wiring mode. 3, Tools/Preferences command, you can pop-up the PCB system parameter settings dialog box. 4, the definition of the device in the network table starts with [starts] and ends with . 5, the definition of the network in the network table ends with (start, end). 6. Draw the schematic diagram and load the component library before placing the device. 7, Protel, 99SE provides two different network grids: line and dot. 8 、 schematic design tools include drawing buses, buses, points in and out, placing components, drawing wires, placing nodes, placing power, placing network labels, input and output points, circuit block diagrams and so on. 9. The network table is the data of each component in the circuit diagram and the data of the network connection between the components. 10. The component list is used to sort out all the files in a circuit or project file, including name, annotation, encapsulation and so on. 11, PCB component layout of the basic principles. (1) the connection between the high frequency components should be shortened to minimize the distribution parameters and the electromagnetic interference between them, and the input and output components should be kept as far away as possible. (2) for those large and heavy, high heat components, such as LM317, LM7805 and other applications, heat sink to be fixed, thermal components should try to stay away from these heating components. (3) there